zen

Well-Known Member

Events Planner

• Nov 28, 2011

• #1

7 of them..really thin ones (thinest in kit,about 1/2 inch dia)

were none like them in block to replace...

my block (and car) is rangie classic,kit i expect was for p38...
only place i recon they could have gone is on solenoids somewhere,but none to be found to replace.

??????


p.s. feckin bloody allen bolt snaped in block,one way vave end..flush with block!!(on removing i add!)what a fecker drilling it out and retapping!!if this leaks after this i will be replacing with yankie air system!

 

wammers

No longer with us, RIP

Donater

• Nov 28, 2011

• #2

They will most likely be for the solenoid shafts. Not every kit supplies them. Remove solenoid valve, two long screws. Then split solenoid valve by removing two self tappers. If you pull this apart then pull solenoid shaft cover out of plastic holder these O rings seal solenoid shaft outer cover to plastic holder.

 

Last edited: Nov 28, 2011

zen

Well-Known Member

Events Planner

• Nov 28, 2011

• #3

got them,but they were about an inch in dia...these seemed like they were for the solenoid shafts, yet none were fitted???

 

wammers

No longer with us, RIP

Donater

• Nov 29, 2011

• #4

zen said:

got them,but they were about an inch in dia...these seemed like they were for the solenoid shafts, yet none were fitted???

Click to expand...

There are for solenoid shafts. Very thin O rings, that's where they go, push solenoid metal cover out of plastic housing, they seal flared end of shaft of metal cover to plastic housing.

 

Last edited: Nov 29, 2011

enery8

Active Member

• Nov 29, 2011

• #5

Here is some info I picked up on the internet, it is part of a very good write up by PaulP38A. Here is a link in case anyone wants to have a look.

 

Attachments

• 
  sol1.jpg

  104.5 KB · Views: 352
• 
  sol2.jpg

  104.4 KB · Views: 177

zen

Well-Known Member

Events Planner

• Nov 29, 2011

• #6

thanks..yes i found where they go !

 

M

MELBUTCH

Member

• Nov 30, 2011

• #7

Zen

What is the Yankee air system? MB

 

996TURBO

Active Member

• Nov 30, 2011

• #8

I guess it's the MARS kit. Inflation valves for emergency

 

enery8

Active Member

• Nov 30, 2011

• #9

enery8 said:

Here is some info I picked up on the internet, it is part of a very good write up by PaulP38A. Here is a link in case anyone wants to have a look.

Click to expand...

:doh: Should have been 2 different pictures. Here is the other one in case anyone wants it!

 

Attachments

• 
  sol1a.jpg

  106.4 KB · Views: 145