awillemsen
Active Member
An EAS update, and a new problem.
Got a new compressor, valve block seal kit, exhaust diaphragm, air dryer and exhaust filter. All fitted, and suspension now goes up and down fine.
Except I've got a leak. Where pipe 6 goes into the valve block, the pipe has a very small split right where the collar thing is. Can I simply chop the end of the pipe off (I think there's enough before the bend)?
Got a new compressor, valve block seal kit, exhaust diaphragm, air dryer and exhaust filter. All fitted, and suspension now goes up and down fine.
Except I've got a leak. Where pipe 6 goes into the valve block, the pipe has a very small split right where the collar thing is. Can I simply chop the end of the pipe off (I think there's enough before the bend)?