stevebrookman

Well-Known Member
Hello all,
Last couple of weeks seems the front of my Range Rover seems to be riding in extended mode whilst the rear is in standard mode.Will drop when I put it into access mode but the front is still higher. Waiting for a nanocom to be delivered and my RSW solutions eas cd (which I found after 11 years) is kaput.

This is what it looks like (road appears sloping but its not-and its like this all the time)
Any pointers please.
x0Xscfj.jpg



Regards

Steve
 
Mine lost its calibration for some reason and dumped the rear LH corner down and lifted the front..

A simple recalibration sorted it, easily done with a tape measure and RSW software, making sure you are not in the vehicle when doing it and the ground is level.

The height sensors themselves are just simple potentiometers very simple to check once off the vehicle.

Three pins in total two outer and one inner, the outer ones are the either end of the track and the centre is the sweeper.

With a multimeter check the resistance of the two outer pins, you should get a resistance reading, if not and you get an open circuit it's junk, however as yours isn't throwing an EAS fault "yet" this probably isn't the case.

Next up check the resistance of the centre pin while running the arm through its full travel, slowly looking for any spikes in the resistance or any areas where it goes open circuit, the latter being the issue with mine.
 
Mine lost its calibration for some reason and dumped the rear LH corner down and lifted the front..

A simple recalibration sorted it, easily done with a tape measure and RSW software, making sure you are not in the vehicle when doing it and the ground is level.

The height sensors themselves are just simple potentiometers very simple to check once off the vehicle.

Three pins in total two outer and one inner, the outer ones are the either end of the track and the centre is the sweeper.

With a multimeter check the resistance of the two outer pins, you should get a resistance reading, if not and you get an open circuit it's junk, however as yours isn't throwing an EAS fault "yet" this probably isn't the case.

Next up check the resistance of the centre pin while running the arm through its full travel, slowly looking for any spikes in the resistance or any areas where it goes open circuit, the latter being the issue with mine.
You said exactly the same in October 2020. 'enery
 
I was reminded today I haven’t got a scooby when it comes to my drivers seat not working despite spending hours trying things and changing outstations and harnesses that’s hours I will never get back so off out to get some more fish for the pond and on the way call into local Indy and try get auto. Electrian out to me
 

Similar threads