Hi, I am thinking about dual alternators each charging it's own battery in completely isolated circuits. One for winch etc, and one for the general car electrics.
I was going to add a solenoid so you could switch the batteries to parallel mode when either was getting flat and needed a boost. (I.e. Connect them both together)
Do you think I also need to add another to break the second alternator charge feed to the battery so I don't end up with 2 alternators output connected together (they are not the same output Amps)? I could put this on the same switch.
I was concerned at they may fight against each other if connected together
Thanks again in advance for your help!
Rob
I was going to add a solenoid so you could switch the batteries to parallel mode when either was getting flat and needed a boost. (I.e. Connect them both together)
Do you think I also need to add another to break the second alternator charge feed to the battery so I don't end up with 2 alternators output connected together (they are not the same output Amps)? I could put this on the same switch.
I was concerned at they may fight against each other if connected together
Thanks again in advance for your help!
Rob