haigy · Dec 14, 2014

The other day my 96 300tdi drivers seat took a slump and i was left on the subfame. Now removed the seat and it has split the rubber on 1 side so is no good.

Looked and new 1 is 49 quid and 2nd hand are around 25 quid.

How easy are they to fit or am i better off getting a new seat and fitting that

joshremlin · Dec 14, 2014

thats what happened to mine so i fort id do a temp fit thinking it was going to split again but it ant so its now a permanent repair i can't tell diffrence to before it split.

thats it repaired took all of 20 minutes with percing the rubber and threaded through rope.

patmac · Dec 14, 2014

I have used paracord on one of mine but found it a bit hard so on my second attempt I used bicycle inner tube instead of the diaphragm. Far more comfy, hardwearing and free. simply cut the diaphram away and looped the inner tube around the 2 rods on the sides. But then again im a tight git
.

diapason · Dec 14, 2014

Exmoor Trim sell them and will rebuild your seat for you too.

iwantone · Dec 14, 2014

I pit a pillow under there. Bit firmer than what it was and probably more like the way it was new.

haigy · Dec 15, 2014

Some very good ideas there guys cheers

ronsealdeath · Dec 15, 2014

I use cable ties. Work fine.

janderson41 · Dec 15, 2014

As a temporary repair I used cable ties at about 2" intervals.
Then ordered a new one, better design, from Craddocks for £34.20 inc vat and delivery.
Definitely worth it. Made a huge difference

haigy

Well-Known Member

joshremlin

Active Member

patmac

New Member

diapason

Member

iwantone

Active Member

haigy

Well-Known Member

ronsealdeath

Sagging Member

janderson41

Active Member

Similar threads