sp00k

sp00k

Well-Known Member
Hi,

I'm wondering what the best way would be to drill a series of 20mm holes in thin steel sheet?

The holes are for switches, so need to be accurate.

I was thinking of using a hole punch to mark the pilot holes and then drilling with a 20m holesaw. Alternatively I could clamp it to some plywood and start off the holes in the wood?

Any tips appreciated, I don't want this to look crap!
 
Clamp to wood and drill through metal into wood. Wood will help hold the steel rigid while you drill.
Dot punch to mark where holes are to be, not difficult just measure twice and cut once:)
 
Stepped hole saws. There are some in Aldi at the moment, low cost and work well. You should still make sure the metal is clamped well - if it starts to spin it could gut you.:eek:eek:
 
Hole punch.
Drill an 8mm hole. Assemble punch over sheet. Tighten using Allen key.
Voila perfect 20mm hole. Think my punch was only 5 or 10 quid and a much better hole form than a drilled hole.

Good on both steel and allys so long as the plate ain't too thick.
 

Attachments

  • image.jpg
    image.jpg
    662.9 KB · Views: 238
Last edited:
Might be a bit thick for a punch? Probably about a mm. Thick enough not to bend or deform.
 
Specs say they'll do 16 gauge 'metal'.

I've put 3mm ally chequer plate through mine for an aeriel on the wing without problem. Just keep it lubed!
 
arc said:
Hole punch.
Drill an 8mm hole. Assemble punch over sheet. Tighten using Allen key.
Voila perfect 20mm hole. Think my punch was only 5 or 10 quid and a much better hole form than a drilled hole.

Good on both steel and allys so long as the plate ain't too thick.
Click to expand...
This is the way to get a professional finish. As said keep it oiled.
 
step drills is availiable in mm too, thats a smallish one, mine goes up to 25mm I think, I also have a 20mm cone drill (stepless) and a rasp bit.

step is by far the next best thing to a punch :)
 
Punches are great, but you have to buy one for each size. Slow as well, I found, as you have to drill a hole, assemble the punch through it, then make the hole. Excellent finish though.
 
Get a nice friend who has access to a CNC miller and get them to mill them out :) super accurate and ver neat :)
If your near oldham I'd do it for you
 
My vote's for the Step Drills too. You can get a set of three from Amazon for very little money. They're designed to drill perfectly round holes into thin materials (but don't use them on Stainless unless you buy a £80 cobalt one - another story).
 
You must log in or register to reply here.

Similar threads

Flossie
P38A Fixed the 'CLAK' noise when opening doors. With pics.
Replies
8
Views
2K
Flossie
Flossie
steve2286w
Rear Axle refurb - welding issue
Replies
18
Views
2K
steve2286w
steve2286w
A
Puma 110 Utility - rear protection
Replies
3
Views
653
tottot
tottot
gstuart
Other Battery charger lead
Replies
1
Views
397
gstuart
gstuart
B
Bad situation that I have made worse.
Replies
13
Views
816
Colthebrummie
C