Trewey
Cockernee, Pasty munchin bastid.
Sort of, but that doesn't show the detail like this...
Attachments
Trewey
Cockernee, Pasty munchin bastid.
Hmm, mine is like this:
That's right - mine is just showing the detail / exploded diagram of the drop-arm ball joint. Yours shows it assembled.
discomania
Well-Known Member
OK three pictures of essentially the same bit... I think Trewys wins.
Last edited:
discomania
Well-Known Member
discomania
Well-Known Member
What do you need to replace?
discomania
Well-Known Member
You have a flat drop arm... from JA019110 they used these...
Right, then you need... RTC5869 and RTC5870
Right, then you need... RTC5869 and RTC5870
Last edited:
Trewey
Cockernee, Pasty munchin bastid.
The one on the end of the drop arm!
(i.e. closest to the steering box).
discomania
Well-Known Member
Hang on I will check what you need quantity wise.
discomania
Well-Known Member
Nah trewy we were both led astray until he mentioned it was a flat drop arm not cranked, at that point they don't have the difficult pain in the ass drop arm ball joints, they just have another rod end style joint.
I am now trying to remember if he needs 3 of 1 and 1 of the other, because the drag link doesn't need to adjust the same as the tracking rod.
I am now trying to remember if he needs 3 of 1 and 1 of the other, because the drag link doesn't need to adjust the same as the tracking rod.
Last edited:
discomania
Well-Known Member
RTC5869 and RTC5870 for the tie rod OK 1 of each, RH and LH threads.
Then you need one RTC5869 for the end of the drag link (wheel side)
Drop arm side is a RTC5870.
Get new clamps (with nut and bolt).
Then you need one RTC5869 for the end of the drag link (wheel side)
Drop arm side is a RTC5870.
Get new clamps (with nut and bolt).
Last edited:
