Where’s_That?
Member
Honestly it was so badly rusted that it’s difficult to tell, if it was homemade then it was done by someone who knows how to fabricate though. I certainly wouldn’t classify it as a crossmember though, it’s made out of 1.5 inch box section, I would guess it was more of a floor support. I’ll hunt around for some photos and see if anyone can supply me with any of what the underfloor of a DC should look like!
The seatbelt mounts were attached to the C post where the floors and the Post met, again they didn’t look standard and they were only angle section cut to length. Although they also used the same bolts as the ‘crossmember’ that I’m trying to identify used.
The seatbelt mounts were attached to the C post where the floors and the Post met, again they didn’t look standard and they were only angle section cut to length. Although they also used the same bolts as the ‘crossmember’ that I’m trying to identify used.
