Yep, the hinges are the same fitting although different design...
ps. bottom hinge can be replaced without removing the door.
> Remove the spare wheel
> Remove the door card:
- 6 x PZ screws in subwoofer grille + 4 under grille, then 8 x PZ machine screws, then disconnect the cable to the amplifier and remove the speaker/amp assembly
- 2 x 10mm Head bolts holding the grab handle
- 1 x PZ screw in door latch handle trim
- prise off the door card
> Make sure the door is fully opened and the checkstay is fully locked
> Undo the two bolts (13mm head) fixing the hinge to the door (one is under a plastic grommet)
> Remove the three bolts fixing the hinge to the body
> At this point you'll need to remove two rivets holding the plate to the side of the door, I just removed them with a chisel and a big hammer - although a grinder may be a better choice!
> Once these rivets are removed you should be able to slide the hinge into the car and out of the door - a little jiggling of the door gives the clearance needed to fully withdraw the hinge
> Insert the new hinge and fit the two bolts into the door then maneuver the door to line up the bolts into the body - a helping hand may assist at this point
> Refit the door furniture
> Marvel at the sound of silence over bumpy stuff when your rear door isn't trying to fall off!
I didn't bother refitting the rivets on the new hinge, can't see it going anywhere!