T

Tonydatiger

New Member

• Nov 11, 2012

• #21

Lookin good!

 

nrgserv

Well-Known Member

• Nov 11, 2012

• #22

puppysandwich said:

The only other problem I had was the flexible brake pipe that connects between the bracket on the floor support bar and the rear "splitter block" was the wrong fitting as can be seen in the pic, so for now I've left the copper brake line inplace, theres plenty of slack in it to allow for movement, so it might even stay there.

Click to expand...

it'll deffo fail a test on that!
otherwise, compliments on the welding.

 

puppysandwich

New Member

• Nov 11, 2012

• #23

nrgserv said:

it'll deffo fail a test on that!
otherwise, compliments on the welding.

Click to expand...

Cheers! It might, but then its not going to cost me anything to sort out because I'll send the flexihose back and get it replaced.

 

S

serious1

Member

• Nov 27, 2012

• #24

just done my aswell not as bad as yours tho !! wot i did was i cut out a old floor of a disco that was not that bad then welded it in job done for £25 !!

 

GreenHornet

Well-Known Member

• Nov 29, 2012

• #25

Nice job. Thorough and neatly finished. Well done.

Recommend new brake flexi sooner rather than later and it's all good.