Hello I am in deep problems and I don't know what to do now.
I was driving down the road the other day and all of a sudden my clutch pedal went to the floor looked under the car and oil was leaking around the bell housing so I changed master cylinder and slave cylinder. I have tried to bleed it up I have been using this easy bleed when I am using it I have got abit of a clutch but soon as I take the air line off the clutch pedal goes straight to the floor. The pin which the slave goes in to I can pull out about 2 and a half inch and push in quite easily. the pin when pushed in sticks out about 10-15mm and won't go in any more.

What the hell is going on with it I can't rap my head round it please help

try bleeding using the pedal and a pipe and jar

Tried bleeding for 2 hours all different methods nothing....

I use the easy bleed kit connected to the tyre for pressure and I have got abit of a clutch but when I take the air line off the clutch pedal goes back to the floor

have you still got air bubbles flowing through

Sounds like a possible broken release bearing fork.

Peter

The clutch fork has gone, fluid is from slave cylinder because it travelled to far, sorry mate but it’s engine or gearbox out to replace, check condition of clutch while you’ve got it apart or you may need to do it all again.