DiscoPol
Well-Known Member
Kirk take your number off mate and just send him a pm with it instead.
Unclejessie
New Member
If only I knew how!
Thin_trucker
Active Member
Assuming its manual, I'm after the plate from the transfer tunnel. It's black, steel, about 18" long, 10" wide, both gear sticks poke through it and it has lots of rivets holding it - 20ish around the outside and about 10 around a smaller plate / gaiter around the gear lever.
Can you pm a price including post please? (For big plate including any rubberboots etc that are attached to it).
Can you pm a price including post please? (For big plate including any rubberboots etc that are attached to it).
£50 buys the four, two of them are good, two of them have bubbling of the paint. One of those two has it's centre cap missing. Hence cheap price.
Sorry, i'd like to help but i dont have time to take all of that apart, the body is going for scrap next weekend.
I'd like to say yes, but it's over at my mates in Essex at the moment. I cannot get over there to open up for you this week and he'll be running it in on Saturday.
Thin_trucker
Active Member
Don't forget me
Sorry mate, I did miss your post. The bit you are after was not in the vehicle when I bought it as the po had just put a new gearbox in.
Thin_trucker
Active Member
Doh! No problem, thanks for the reply
No, the wheels are ES but the vehicle isn't, so it doesnt have electric seats. Cheers.
Body has now gone to scrap. Lots of bits kicking around here still. Some of which i've put on ebay.
scammell sam1986 | eBay
scammell sam1986 | eBay
