lrjohn

Active Member
So I knew the heater control panel in the Discovery 1 I bought was cracked, but I didn't know it was actually in two pieces till I removed it today!
I have had a quick look to see if I can find a replacement with no luck – if you or you know someone who has one I would be very grateful!

Alternatively has anybody had success in gluing these trim pieces together, if so what adhesive have you used? Any advice much appreciated

20240630_183551.jpg
 
Fill the back with JB weld or ct1 using cut up paper clips as a streaghtener.
Or you could use a soldering iron and melt the plastic over to give a temporary repair before you fill the back.
As regards making it look good from the front. No clue :-(
 
There are youtubes on mending plastic. It can be done. Most seem to use stick-on silver paper stuff, on the front side then making up a sort of glue gun with a copper pipe beaten into a shape so you can feed cable ties down it. This you attach to an ornery soldrering iron.
Best of luck.
 
So I knew the heater control panel in the Discovery 1 I bought was cracked, but I didn't know it was actually in two pieces till I removed it today!
I have had a quick look to see if I can find a replacement with no luck – if you or you know someone who has one I would be very grateful!

Alternatively has anybody had success in gluing these trim pieces together, if so what adhesive have you used? Any advice much appreciated

View attachment 320485
BTR3672JUL is the part number, you may find a new item if you search, but there is a second hand one on eBay for just £50. https://www.ebay.co.uk/itm/17615502...6VSJ8D&hash=item2903a86e8e:g:yXcAAOSwZJZllzq0
 
There are youtubes on mending plastic. It can be done. Most seem to use stick-on silver paper stuff, on the front side then making up a sort of glue gun with a copper pipe beaten into a shape so you can feed cable ties down it. This you attach to an ornery soldrering iron.
Best of luck.
1719927336673.png
 
There are youtubes on mending plastic. It can be done. Most seem to use stick-on silver paper stuff, on the front side then making up a sort of glue gun with a copper pipe beaten into a shape so you can feed cable ties down it. This you attach to an ornery soldrering iron.
Best of luck.
1719927363859.png
 
i successfully glued centre console and lower seat surrounds using plumbers pvc weld adhesive. needs to be left 24hrs to set
 

Similar threads