The Mad Hat Man

The Mad Hat Man

Well-Known Member
LZIR Despatch Agent
I need to fit my Disco wing(s) back on.....
between the outer and inner wing (where it is bolted along the top) is a layer of thick bitumastic, or summat similar. where can I get this stuff or summat better?

oh - and by the way - roofing screws - those with built in washer and rubber seal are ideal for bolting it back together :D.
 
You could use mastic the stuff that comes in a tube like silicone just let it go off for a bit before assembly its there to stop reaction between the ali and steel thats what i used to do on the series.
You can get the same stuff on a roll but f**k knows where

Just found this MHM ?
http://www.sealumet.co.uk/008tapes.html
 
Last edited:
thats good stuff, we use sikaflex to seal caravans, the pins u want are 'tek pins' used to have boxes ov em
 
i have half a roll of ten m/m neoprene strip with a sticky tape on one side. i will use this when i replace the wings on my discovery. there is a place in derby opposite rollerworld skating rink that sells all kinds of rubber and neoprene to all kinds of applications. i would say dont use silicone get a propper seam sealer type stuff for auto applications.
 
u cud use caravan sealent the stuff that comes on a roll and seals for years, towsure sell it and ive sin it on ebay too
 
You can use any mastic sikaflex type sealant in a tube, or use dum dum, which is probably what is there. The caravan non drying sealer is good stuff!
 
You must log in or register to reply here.

Similar threads

B
Smart Key Issue - Disco 4
Replies
0
Views
1K
BourneFree
B
dag019
Where to buy an old land rover
2
Replies
31
Views
4K
dag019
dag019
Tango91
  • Poll
Disco 2 Things I wish I knew when I took the body off (99 D2 TD5)
Replies
8
Views
3K
FlatbedPilot
FlatbedPilot
Goc3k
Discovery 1 SOLD 1997 300TDI manual D1, Winchester
Replies
16
Views
3K
Goc3k
Goc3k
K2tnt
Disco 1 Wheelarch liners, bonnet release, air filter mounts
Replies
3
Views
517
K2tnt
K2tnt