N

njackson

New Member

• Jun 24, 2015

• #1

to start with, will only start with all doors shut, is this standard or reverse switch fault?
secondly, if I push the drivers door lock down it doesn't lock the other doors? I also cannot get the car into the mode to program the single blip remote. any help guys and girls? thanks
nathan

 

TrilloThrillo110

Active Member

• Jun 25, 2015

• #2

What year?
Mines a 200 series 1994 and I can start mine up with doors open.
With the lock my passenger door does something like that. It's broken
So dunno about yours, but it would appear something may not be right, but then again, I may be comparing an early one to a later model one.

 

ronsealdeath

Sagging Member

• Jun 25, 2015

• #3

njackson said:

to start with, will only start with all doors shut, is this standard or reverse switch fault?
secondly, if I push the drivers door lock down it doesn't lock the other doors? I also cannot get the car into the mode to program the single blip remote. any help guys and girls? thanks
nathan

Click to expand...

Why not post an introduction and a photo of your disco, before you expect a load of advice

 

N

njackson

New Member

• Jun 25, 2015

• #4

didn't know I had to post an introduction to dispense help from what I thought would've been a more than helpful community. I'll post an intro then let the knowledge flow👍

 

MGBGTV8

Active Member

• Jun 26, 2015

• #5

There's clearly some sort of electrical fault if all the doors must be closed for the vehicle to start.
Operating the lock pin should activate the central locking on all other doors including the tailgate. Time to get the drivers door card off and investigate.

 

N

njackson

New Member

• Jun 26, 2015

• #6

hi there. I've got the drivers door card off, everything is connected on the latch end. is it possible a faulty latch/ actuator would stop it?
or if the alarm or the locking ECU was disconnected would that do it too?