depends on who and where , used box tend t be cheaper, but you need to ascertain fault first

Taken it for a little test drive and noticed it works and responds like it should in low gear...when in high it's sluggish...slow off mark and does what I said above with reverse.

Did the same thing when I started it....in high...in reverse foot flat down and staying at idle rev...nothing kicked in until I put in park and revs shot up since foot on excelerator...the straight in to reverse but took about 3 seconds to slowly reverse until revs picked up.
 
Taken it for a little test drive and noticed it works and responds like it should in low gear...when in high it's sluggish...slow off mark and does what I said above with reverse.

Did the same thing when I started it....in high...in reverse foot flat down and staying at idle rev...nothing kicked in until I put in park and revs shot up since foot on excelerator...the straight in to reverse but took about 3 seconds to slowly reverse until revs picked up.
Did you get to the bottom of this i am having the same problems after fresh gear oil will only select reverse when in low and in high just revs as in neutrel
 
Did you get to the bottom of this i am having the same problems after fresh gear oil will only select reverse when in low and in high just revs as in neutrel


Hello Dave,

I’m afraid not!!! It is still happening....I got a feeling that the pack within the auto box is on its last legs :-(
 
Did you get to the bottom of this i am having the same problems after fresh gear oil will only select reverse when in low and in high just revs as in neutrel
Hello Dave,

I’m afraid not!!! It is still happening....I got a feeling that the pack within the auto box is on its last legs :-(
Just an update i messed around with mine today cleaned xyz switch plug and ecu with brake cleaner and also gearbox ecu behind glovebox now all is good hopefully stays that way
 
Was it easy to remove the XYZ switch and do the repair...well clean inside it?
Yes i took a pic of location to put it back then two 10mm bolts and 13 mm bolt and off drill the top of the rivets out and your in mine was cleanish inside but bit of dirt cane out then zip tied back together
 
Yes i took a pic of location to put it back then two 10mm bolts and 13 mm bolt and off drill the top of the rivets out and your in mine was cleanish inside but bit of dirt cane out then zip tied back together

Did it take long? I might need to do that myself
 

Similar threads