K

Karls

Active Member

• Aug 29, 2017

• #1

I'm about to install new seats onto a YRM repaired seatbox but have no reference for where to drill for the set frame fixings.
Can someone be good enough to take a reference measurement from the outer edge of the seatbox to the bolt hole centres? That would be a great help. Many thanks in advance.

 

Paul D

Old, nackered 'n broke, but the Landy is fine . :)

Events Planner

• Aug 29, 2017

• #2

From an '89 90 .. Two at the front, two at the rear, slightly different 'cos it isn't an easy answer to give.

In both cases I've tried to centre the tape on the bolt head, hope this is OK ..

 

L

lynall

Well-Known Member

Full Member

• Aug 30, 2017

• #3

Just to confuse things, 1993 90, front bolts 2 7/8 inches, rears 3 1/8 inch, both measured same was as Pauls.

 

K

Karls

Active Member

• Aug 30, 2017

• #4

Thanks Paul & Lynall, fantastic help guys, cheers!

 

K

Karls

Active Member

• Aug 30, 2017

• #5

lynall said:

Just to confuse things, 1993 90, front bolts 2 7/8 inches, rears 3 1/8 inch, both measured same was as Pauls.

Click to expand...

Lynall, mine is a '85 90 Truck cab so I think I'll probably go with Paul's dimensions but thanks all the same.

 

Last edited: Aug 30, 2017

L

lynall

Well-Known Member

Full Member

• Aug 30, 2017

• #6

I notice pauls seat box seems to have the option to drill in three different places, wonder if its for different seats?

 

Paul D

Old, nackered 'n broke, but the Landy is fine . :)

Events Planner

• Aug 30, 2017

• #7

lynall said:

I notice pauls seat box seems to have the option to drill in three different places, wonder if its for different seats?

Click to expand...

Sorry, dunno .. helpful?

 

K

Karls

Active Member

• Aug 30, 2017

• #8

lynall said:

I notice pauls seat box seems to have the option to drill in three different places, wonder if its for different seats?

Click to expand...

Either that or it's just allowance for Land Rover build tolerances?