Cossie David

New Member
Hello, just jumped over from the Range Rover forum, change the bush on the rear axle of a Freelander, is it just a matter of undoing the bolts and pull out the old bush or as i am thinking a lot more involved than that, we have a very attractive female moved next door with a Freelander so say no more:D
 
Hello, just jumped over from the Range Rover forum, change the bush on the rear axle of a Freelander, is it just a matter of undoing the bolts and pull out the old bush or as i am thinking a lot more involved than that, we have a very attractive female moved next door with a Freelander so say no more:D
durty boy............;)
 
Getting to her bush could be a bit fiddly...best done in dark so you can feel your way round but get it wrong and could end up in sh1t..:rolleyes:

On serious note

Easiest way Ive found is to drop rear subframe ...not as drastic as it sounds ....
Jack motor and support under the standard sill jack points
Undo 4 off 18mm chassis mounting bolts by 3/4 inch each and you will see subframe drop

Remove 3 bolts holding bush and replace bush...

20 mins job depending how long you want to fondle bush for.
 

Similar threads