Hi all , I need to replace the drop arm and bottom seal on my 300tdi 110 . I need some advice on the best way to reach it . There seems to be little room to to maneuver a spanner and a lot of pipes and hoses going across the top of it . On the Trailerfitter's Toolbox videos on YouTube the wing appears to be off the vehicle when he's changing it . Any advice on how to tackle the job ? Thanks , Gerry .
tottot
Well-Known Member
Probably had the wing off for filming, not necessary to just change the box. Both arm and seal can be changed in situ.
If the arm can be moved side to side, back and fore likely its worn and need to be changed.
Getting the arm off is the first problem, it is on a taper and is usually tight.
Britannica Restorations have good video's.
If the arm can be moved side to side, back and fore likely its worn and need to be changed.
Getting the arm off is the first problem, it is on a taper and is usually tight.
Britannica Restorations have good video's.
Thanks Grebby , but I am in Ireland . I would just use an angle grinder and chisel on the arm , it's the lack of access to the fluid pipe nuts on the steering box that bothered me . Maybe when the steering shaft is removed I'll be able to get my hand in under all those pipes that run over the steering box .
