Mark13

Member

• May 11, 2018

• #1

I'm going to be replacing all my door seals and the drivers catch this weekend. While I'm doing it I was wondering if there is a way of changing the door alignment, I think my drivers doors is about 2 or 3mm too low. It's not very much I know but it would be nice to correct it if I can. If there is alignment adjustment what is the procedure in aligning the doors?

 

Dippypud

Never Knowingly Understood

Full Member

• May 11, 2018

• #2

Mark13 said:

I'm going to be replacing all my door seals and the drivers catch this weekend. While I'm doing it I was wondering if there is a way of changing the door alignment, I think my drivers doors is about 2 or 3mm too low. It's not very much I know but it would be nice to correct it if I can. If there is alignment adjustment what is the procedure in aligning the doors?

Click to expand...

What kind of handles you got? Lift up type or push button?
Ed: Not all door seals are the same, OEM good quality or blue box carp ...

 

Mark13

Member

• May 11, 2018

• #3

I have push button type.

 

neilly

Well-Known Member

• May 11, 2018

• #4

Mark13 said:

doors is about 2 or 3mm too low.

Click to expand...

Where??

Cheers

 

Mark13

Member

• May 11, 2018

• #5

The could do with rising about 3mm (drivers door)

 

landowner

Pensioner Pete

Full Member

• May 11, 2018

• #6

You leave the door where it is and adjust the body to suit

Or move the hinges up on the bulkhead

 

Hippo

Lord Hippo

• May 11, 2018

• #7

I always thought tratter doors were realigned by opening the door, placing a length of fence post int door apperture, then slamming the door shut. Open the door to release wood after slamming.