K

Kevinsv

Member

• Feb 21, 2020

• #1

Hi can anybody help me my freelander 2 2008 cranking but no start fault codes p2564-37 p0340-00 p0380-00 p0642-00 they are all circuit A and state permanent do you think it needs a ECM thanks any help suggestions

 

Shimsteriom

Master Procrastinator

• Feb 21, 2020

• #2

Hello

 

T

td4van

Well-Known Member

• Feb 21, 2020

• #3

I would say do some diagnosis using a multimeter and wiring diagram first before condemning ecm

when did the fault occur and what has happened to the car prior to the fault?

 

Nodge68

Well-Known Member

• Feb 21, 2020

• #4

I'd be checking for a wiring fault, that is affecting the 3 items (MAP sensor, Cam sensor and glow plug circuit) that those codes refer too.
Was there any warning to this fault? Or did it just not start one day?

 

K

Kevinsv

Member

• Feb 22, 2020

• #5

td4van said:

I would say do some diagnosis using a multimeter and wiring diagram first before condemning ecm

when did the fault occur and what has happened to the car prior to the fault?

Click to expand...

Hi have tried to find a good wire diagram Haynes manual even paid on line to download one but none show the 5volt A diagram good when I got it it was not working they said it was injections I have cleaned and tested them 2 had blocked stream and only one glow plug worked fitted new Bosch glow plugs I put new diesel filter in and used a hand pump to pull fuel through filter one thing happen I forgot to put return pipe in filter tried to start and no fuel came out

 

K

Kevinsv

Member

• Feb 22, 2020

• #6

td4van said:

I would say do some diagnosis using a multimeter and wiring diagram first before condemning ecm

when did the fault occur and what has happened to the car prior to the fault?

Click to expand...

Can you recommend a good wiring diagram please

 

K

Kevinsv

Member

• Feb 22, 2020

• #7

Kevinsv said:

Can you recommend a good wiring diagram please

Click to expand...

Thanks for that do you know by any chance where I can get one of theses pipe connectors it's had its top saw off thanks for any help new and trying to find my way round site

 

Attachments

• 
  IMG_20200210_213517.jpg

  176.5 KB · Views: 188

T

td4van

Well-Known Member

• Feb 24, 2020

• #8

Can’t see clearly where that pipe is from - which part of the engine is it from?

check the powers and grounds for the ecm as first port of call. The 5 volt circuits are all separate in the car (not sure on internal to ecu) but a faulty sensor could pull the voltage down and cause the P0642 to be set. Check the cam sensor and turbo actuator and map sensor for 5 volt supply

if you send me your email address via a private message I can send you a pdf of the wiring diagram for the ecm