Mercmancdi
Member
That's what he said , after I change harness he's going to call and run it through again , although when doing harness I am going to do injector bleed off. I also add that I did find a wire broke and rejoined at air temp sensor (joined with standard screw conectors much too big for small wire ) but he checked and joint was not correct but ok , but if it's been broke there then there could be others so regardless , I don't think conectors and harness is in great condition in general , and I want to keep this landy a while so trying to get in good as condition as I can for long term .So will work through bit by bit , one of the air sensors I replaced had no tip on it and I destroyed the one in the inlet by forgetting to remove before soaking overnight in oven cleaner. Lol my fault