Hi All , I tried to replace a core plug in my 300tdi but the core plug just slides into it's proper final position without any pressure . I reckon a tap of a hammer would send it into the block . I'm assured the plug is the correct one for the engine , it measures just under 53mm . Could I use a slightly oversized plug , or use some sort of epoxy to keep it secure ? Thanks , Gerry .
jamesmartin
Well-Known Member
its either wrong plug or a poor one ,erc4996 is the number and they need to be a tap in fit using a slightly smaller socket than the plug ,its best to loctite plugs first, it needs to be correct fit as the pressure makes outer each of plug grip the block ,which is why they should be just further in than flush
blue beasty
Leaks an prone to bits dropping off
I fitted a britpart core plug a couple of years ago and was worried because it didn't seem a tight fit. leaked.
I'd bought a few and after some investigation realised that although they were the right size and there was very minimal variation in diameter there was no flaring on the shoulder and so weren't a proper pressed fit.
Sourced a few from and engine tuners workshop not too far away and did it again properly.
I'd bought a few and after some investigation realised that although they were the right size and there was very minimal variation in diameter there was no flaring on the shoulder and so weren't a proper pressed fit.
Sourced a few from and engine tuners workshop not too far away and did it again properly.
blue beasty
Leaks an prone to bits dropping off
Should be 53mm. I suspect you have a poor quality plug like I did. Source a better one
jamesmartin
Well-Known Member
order a better quality erc4996
blue beasty
Leaks an prone to bits dropping off
Britpart and allmakes are about 30p a piece or you can get genuine for 2 quid
ERC4996 | CORE PLUG 53MM DSL/PET 2.5+2/300TDI | Land Rover | Defender 1983 To 2006 | Britcar (UK) Ltd
ERC4996 | CORE PLUG 53MM DSL/PET 2.5+2/300TDI | Land Rover | Defender 1983 To 2006 | Britcar (UK) Ltd
