E

EntropyUK

Well-Known Member
Sorry folks but having a bit of a grey moment. I am looking at repairing a water leak coming rom the front of the engine and was advised to replace the O ring to the coolant pipe that connects into the front of the engine (Rave page 483, actions 10 and 11). I cannot find the part at Island4x4 so either I am missing it or they do not hold it. What is the part number I need to search for?

Also will replace the thermostat as everything will be off. Which one do I go for the LR genuine part (Ouch!) or the Valeo one?
 
Oem min. Is this a v8? Or doezil? On a v8 the stats are gates and cost £60. On a diesel I dunno. Don't buy cheap. Mine didn't close very well. So it never warmed up brrrrr.
 
For the orings, if you have the old ones, you can just measure them and buy them from most hydraulic suppliers.
You could buy a handful that are close and use the one that's the best fit.
 
Sorry thought I said that it's a diesel.
Wazz -Need vehicle daily so cannot strip the part then find a replacement.

JB - Island has 3 thermostat options, Britpart, Valeo £12 (is it OEM?) and genuine LR £38.
 
EntropyUK said:
Sorry thought I said that it's a diesel.
Wazz -Need vehicle daily so cannot strip the part then find a replacement.

JB - Island has 3 thermostat options, Britpart, Valeo £12 (is it OEM?) and genuine LR £38.
Click to expand...

Put the Valeo one in mine a few years ago and it is still fine.
 
I am after the O ring in No. 11 of this diagram. I thought this was the part (LYX000140 in link below) unfortunately different dims for each item so may get both to be safe.

http://www.brit-car.co.uk/product.p...pipe_to_block___2_5l_diesel___p38_range_rover

upload_2018-1-19_13-8-12.png
 
Thanks Gents, I will get that added to my list of parts.

Fell foul to an incorrect description - where do you guys get your part numbers from?
 
I get my part numbers from the Genuine RR Parts Manual - wasn't cheap but worth every penny - and it sits alongside the equivalent Workshop Manual publication.

Two large volumes that stop my desk drifting away and also that I can carry about and make notes in.

They are available for a lend Joss if ya needs them as you're only about ten minutes from my place.
 
Fergie46 said:
I get my part numbers from the Genuine RR Parts Manual - wasn't cheap but worth every penny - and it sits alongside the equivalent Workshop Manual publication.

Two large volumes that stop my desk drifting away and also that I can carry about and make notes in.

They are available for a lend Joss if ya needs them as you're only about ten minutes from my place.
Click to expand...
That was genuine RR but £4.00 +vat they were taking the pi $$
 
You must log in or register to reply here.

Similar threads

pwood999
Freelander 1 [Solved] TD4 M47 Coolant Fitting Part Number Needed
Replies
14
Views
650
pwood999
pwood999
ar1g3
P38A Radiator drain plug o-ring troubles
Replies
7
Views
2K
ar1g3
ar1g3
I
L322 Could anyone help with 2005 RR HSE fluids questions?
Replies
0
Views
583
invisible999
I
S
Ran 300TDi low on coolant ~1300km
Replies
15
Views
2K
currymunster
currymunster
A
P38A Heater matrix o-ring / pipes - advice needed !
2
Replies
23
Views
2K
romanrob
R