Good evening everyone, First post.
Standard series 3 12 volt petrol, had a coil go supernova on me last year and melted lots of low tension wires. Replaces every piece of wire, ballast resistor, coil, ht leads, cap, rotor arm, plugs. After driving around the condensor blows up with amazing regularity. Points also get scorched when this happens but no marks on dissy metal base plate.
Change condensor and points and starts first time until next time.
Usually get mis-fire then, shortly afterwards no go, so time to pull off.
Any help, advice, shoulder to cry on would be of help.
Advantage ? can set points in seconds now with all the practice !!!!!!
Andy K
Standard series 3 12 volt petrol, had a coil go supernova on me last year and melted lots of low tension wires. Replaces every piece of wire, ballast resistor, coil, ht leads, cap, rotor arm, plugs. After driving around the condensor blows up with amazing regularity. Points also get scorched when this happens but no marks on dissy metal base plate.
Change condensor and points and starts first time until next time.
Usually get mis-fire then, shortly afterwards no go, so time to pull off.
Any help, advice, shoulder to cry on would be of help.
Advantage ? can set points in seconds now with all the practice !!!!!!
Andy K