neilcmusic

Active Member
Morning!

Previous owner has replaced choke cable , choke is still on steering column and approx 1ft is still dangling out of other side of bulkhead resting on the engine block (i will cut it off!)
however sensor in cable is not allowing cold start light to go off , someone once mentionned that using a cable tie somewhere,somehow on cable can deactivate light , does anyone know how to do this

Thanks,
 
The switch actuates through a hole in the cable sheath - when the shaft is pulled out the switch drops down. Find that bit and tie-wrap it up. or simply disconnnect the +12 at the switch.

Whaat are you going to use for a choke cable?
 
The choke cable has been replaced by previous owner and is working well , no issues there , he just didnt remove the previous one!
 
really annoys me when people just take the easy route instead of doing it right, you could always buy a new choke cable and install it how it should be so that the light works properly
 

Similar threads