C

colross

New Member

• Dec 10, 2016

• #1

Hi just replaced the clutch and slave cylinder on a 02 freelander td4, not getting any feel in the pedal and no gear selection, have bled down the way pumping the pedal and reverse bled too, I've disconnected the pipe to check the master cylinder and the pedal goes rock solid as it should be! Any ideas would be great. Thinking I may have to rip it all apart again!

 

freelance

Well-Known Member

• Dec 10, 2016

• #2

It is possible that pedal doesn't push master cyl full travel, so not all the air is displaced

 

D

disco_mikey

Active Member

• Dec 10, 2016

• #3

Di you fit the clutch the right way round?

 

andyfreelandy

Well-Known Member

• Dec 10, 2016

• #4

See my thread on this - it involves pushing all air out of master - cannot be done with pedal.

 

C

colross

New Member

• Dec 10, 2016

• #5

I've had the gearbox off again to make sure all was right and it is.
Where do I find the thread for pushing all the air out without the pedal?

 

andyfreelandy

Well-Known Member

• Dec 11, 2016

• #6

https://www.landyzone.co.uk/land-rover/really-low-clutch-bite.287496/#post-3560240

Amongst other useful things - search for my user and 'clutch'