Jeff hymers

Member

• Jul 21, 2017

• #1

Hi all, I posted on here about having no clutch and changed the master cylinder as suggested, worked fine for 3-4 days then nothing again, I managed to get it home by lifting clutch pedal with foot but this morning I can't get it into gear at all any suggestions. Thanks
P.s. I have a 2006 2.0 freelander 1 td4 adventurer.

 

Arctic2

Well-Known Member

• Jul 21, 2017

• #2

It may need bleeding, or the slave could be playing up, I was told by a good clutch person that the master never really need changing on a TD4, if they do very rare, all that is needed is a good bleed through, therefore look towards the slave.

 

Flying Scotsman!

Active Member

• Jul 21, 2017

• #3

Is the pedal stying all the way down?
Is there any 'pressure' in it or is it just floppy?
Still sounds like air in the system.

 

Jeff hymers

Member

• Jul 21, 2017

• #4

There is some pressure but not enough to get it in gear,

 

P

PopRivet

Well-Known Member

• Jul 21, 2017

• #5

I think the Flying Scotman is correct. The oil reservoir is difficult to fill anyway, but the union near to the Master cyclinder can be a sod to tighten properly too.

 

Flying Scotsman!

Active Member

• Jul 21, 2017

• #6

Sounds like still got air in it.

If you pump the pedal does it get better? Does it feel 'harder'?
If so, then its air.
If not then its a mechanical problem.

 

Alibro

Well-Known Member

• Jul 21, 2017

• #7

Open the master and see if there is any fluid left in it. The top just pulls off.