natas

Well-Known Member
I took Pumkin in the bush this weekend.
There is one particular place that I come down a sand dune at a pretty steep angle and have to make a scary turn at the bottom.
I have done this many times with no issues.

This time when I got to the bottom and straitened her out, when I went to shift I noticed that the clutch pedal was down about 3/4 of the way. I pushed it to the floor and was able to change gear but it only came back up a little.:eek:
I put my foot behind the pedal and it came back up with little effort and I continued my journey with no more problems.
Clutch pedal is fine.

Should I be worried?:confused:
It is a fairly new pedal assembly and have never had any trouble with it.

Anything I should check?

Thanks.
 
The clutch pedal spring should pull it back up regardless of what the clutch itself is doing.
Should but doesn't always, I had the same symptoms and it was the slave replaced that and all was well for another couple of years them the master failed too. Replaced that and all is well again, for now.
 
Jesus, I thought this was a new saucy novel
50 shades of grey part 2 :eek:

I took Pumkin in the bush this weekend. What you filth munger !
There is one particular place that I come down a sand dune at a pretty steep angle and have to make a scary turn at the bottom. :hysterically_laughi:hysterically_laughi


I have done this many times with no issues.
 
I took Pumkin in the bush this weekend.
There is one particular place that I come down a sand dune at a pretty steep angle and have to make a scary turn at the bottom.
I have done this many times with no issues.

This time when I got to the bottom and straitened her out, when I went to shift I noticed that the clutch pedal was down about 3/4 of the way. I pushed it to the floor and was able to change gear but it only came back up a little.:eek:
I put my foot behind the pedal and it came back up with little effort and I continued my journey with no more problems.
Clutch pedal is fine.

Should I be worried?:confused:
It is a fairly new pedal assembly and have never had any trouble with it.

Anything I should check?

Thanks.

try the nuts on the master cylinder rod , ive had it as an intermittent fault were the master cylinder rods gets misaligned and jams on occasions
 

Similar threads