L

Landy_Ben

Active Member

• May 17, 2020

• #1

Noticed recently that my clutch pedal on my 1995 300tdi doesn’t return fully to start position.

clutch working fine. Can get all gears and ratios. Just not fully returning.
I can’t lift it back to full with my toe. Next press it does it again.

any ideas?

 

JimS

Well-Known Member

• May 17, 2020

• #2

I had this the other day. In the end I whipped the clutch pedal box out because no amount of faffing about fixed it
It was the spindle, cleaned it up and lubricated and it was like a new pedal
Bleeding the clutch again was a pain though

 

L

Landy_Ben

Active Member

• May 17, 2020

• #3

JimS said:

I had this the other day. In the end I whipped the clutch pedal box out because no amount of faffing about fixed it
It was the spindle, cleaned it up and lubricated and it was like a new pedal
Bleeding the clutch again was a pain though

Click to expand...

Thanks. Will check that. Although as you say no fun bleeding clutch. Anyway to access spindle without?

 

JimS

Well-Known Member

• May 18, 2020

• #4

You could try and access it by removing the cover on the box under the bonnet but as the pin is horizontal you'll probably get more oil on the floor mat than on the spindle. Worth a try. Also assuming the fluid levels are OK

 

Rougharse Racing

Well-Known Member

• May 18, 2020

• #5

Make sure that the fluid level is OK before you do anything else.