I just looked for the heavy duty release bearing and bought it just had n/a under brand. When I first bought the clutch I was new and didn't realise how bad they were
Well it's done and sorted, found the problem, I didn't put the little plastic clip in that holds the bearing to the fork, didn't even know it needed one haha
Well it's done and sorted, found the problem, I didn't put the little plastic clip in that holds the bearing to the fork, didn't even know it needed one haha
Could have been a bit of both, it was the first landy clutch I had done and the last clutch I did of any kind prior to that was about 5 years previous.
I thought you had to have the clips so that the release bearing stayed with the fork
Could have been a bit of both, it was the first landy clutch I had done and the last clutch I did of any kind prior to that was about 5 years previous.
I thought you had to have the clips so that the release bearing stayed with the fork
I'm with you here, once that clip was in it all made sense, without it being pulled away it can stay spinning on the fingers, pretty sure that's why mine over heated. My bite point is a bit high now though but I believe that can be adjusted