Hicap phill
Well-Known Member
Has yours got the release bearing built into the gearbox bell housing ?
Marmaduke
Well-Known Member
No idea cos I've never had it apart..
Hicap phill
Well-Known Member
This presses onto the centre of the clutch
Hicap phill
Well-Known Member
Oh was you in water up in wales??
If you parked it up it(not used it for a week) could just be a bit of rust on the main shaft not allowing the clutch plate to float back
If you parked it up it(not used it for a week) could just be a bit of rust on the main shaft not allowing the clutch plate to float back
Hicap phill
Well-Known Member
While I’m bored...
You can remover the inspection bung & have a look. Can’t remember if you have to remove the selector bracket(think 4 bolts)
(Pictures Are off the net & not my shed floor)
You can remover the inspection bung & have a look. Can’t remember if you have to remove the selector bracket(think 4 bolts)
(Pictures Are off the net & not my shed floor)
Marmaduke
Well-Known Member
I was doing it before I went
Colthebrummie
Well-Known Member
I was going to say, no wonder it's chattering if all those bits have fallen out.
Col
jamesmartin
Well-Known Member
series 2a release bearing is stc1130 same as t/box output bearings
Hi - did you ever resolve this issue? Mine just started doing it at the weekend. Its a S3, but my thoughts are the spigot bush or release bearing/fork. Sounds quite a chatter - especially free wheeling or at low speed coming to a halt. Any input I'd appreciate it - gonna try and live with it until weather improves! Dont fancy lying on the barn floor all over again!
