Lukas018 said:

Evening all,

I am getting a clicking noise coming from the drivers door outstation when doors are unlocked and drivers door open, the car locks and unlocks normally. However it does seem it is trying to lock and unlock. Hard to describe.

I removed outstation and sprayed with electric cleaner etc but got same issue.

Anyone had this or know what it could be?

thanks,

Click to expand...

mozz smith said:

Hi , probably cdl microswitch in drivers doorpack , send martyuk a message see if he has any ready , as your rangie is now 25 yrs old ?? unless doorpack has been changed then its lasted well and time for a new one ,,, marty's well recommended and top lad on this site for doorpacks and other stuff , ok hope you get sorted . regards Mozz

Click to expand...

Datatek said:

Door lock micro switches maybe. When you say you removed the outstation and sprayed it, I assume you mean you sprayed the connector contacts?

Click to expand...

mozz smith said:

Hi , probably cdl microswitch in drivers doorpack , send martyuk a message see if he has any ready , as your rangie is now 25 yrs old ?? unless doorpack has been changed then its lasted well and time for a new one ,,, marty's well recommended and top lad on this site for doorpacks and other stuff , ok hope you get sorted . regards Mozz

Click to expand...

Lukas018 said:

Cheers Mozz will give him a go think it is the original pack. Bloody annoying getting engine sorted and car just sits there for other things to go wrong!!

Click to expand...

Lukas018 said:

Yes sprayed the contacts

Click to expand...

Datatek said:

The Micro switches are IP65 sealed, you cannot spray the contacts.

Click to expand...

Lukas018 said:

For clarity I unplugged the 3 plugs from the bottom of the door outstation, sprayed the contacts on them and plugged back in.

Click to expand...

Datatek said:

Fair enough, but it's usually the actual micro switches that fail. Sometimes it's the little plastic actuator pip that is worn.

Click to expand...

Mark Piercy said:

Hey Lucas, what about the wire removal from the fob receiver?
Not too sure but about it?? @Datatek

Click to expand...

Datatek said:

Wont stop the locks clicking/cycling.

Click to expand...