Aaran_05

New Member

• Feb 26, 2011

• #1

I can get my landy started but i cant turn it off :s its a 2.25 diesel, i turn the key and pull it out but its still running, i pull the lever out, that has a picture of what looks like an engine with a line through it, that slows the engine but doesnt cut it out so ive just been stalling it to stop it :s

any help would be greatly appreciated

 

pobby

New Member

• Feb 27, 2011

• #2

Mine does the same thing
Check for feed at the fuel cut off solenoid when ignition off but engine running
Think mine is getting a feed from the alternator exciter wire keeping it switched on hence why the engine still runs

 

TheKeymeister

Active Member

• Feb 27, 2011

• #3

I could well be wrong, but I assumed the stop solenoid was cable operated - hence the lever. To me if its slowing but not stopping that would indicate the cable needs adjusting, or it's stretched. Worth checking

 

pobby

New Member

• Feb 27, 2011

• #4

What year is the car to have a hand cut off ?
You sure it's not a hand throttle ?

 

TheKeymeister

Active Member

• Feb 27, 2011

• #5

pobby said:

What year is the car to have a hand cut off ?
You sure it's not a hand throttle ?

Click to expand...

As I said I'm probably wrong

Just wondered why they would need a lever if it wasn't cable operated lol, and put two and two together and probably made 5.

 

oxides

Well-Known Member

• Feb 27, 2011

• #6

Follow the cable to the injector pump, make sure the cable outer is firmly clamped then adjust the cable inner so it fully operates the cut off lever. I think it's in section 3 of this...
pdf Land Rover Manuals | Landroverweb.com

 

A

aaronledwidge

New Member

• Feb 27, 2011

• #7

the bar to the left of the steering wheel should be pulled out to cut then engine off on a series engine, only if you have a newer engine fitted will it have an electronic cut out, if the cable is out of adjustment then it will not cut out. on the side of the injector pump there is a lever and cable that pulls it back, this is the cut out, if you would like a photo post back and i will upload one.

 

Aaran_05

New Member

• Feb 27, 2011

• #8

Yeh it does seem to be cable operated, I'll have a go at tightening it as it does look a bit slack

 

rog8811

New Member

• Feb 27, 2011

• #9

This is from a small amount of knowledge having just replaced my engine stop cable (marked in red on attached picture).
Open the bonnet and lift the lever at the bottom of the injector pump by hand, if the engine stops you know it is just an adjustment of the stop cable that is required.

 

Attachments

• 
  deisel 02.jpg

  41.5 KB · Views: 215