After changing my ball joints my abs light is on and its says ABS fault followed by traction failure on message centre.
When i was smacking the hell out of the ball joint my hammer slipped and has cracked a the plastic on the sensor but the wires inside all seem fine with no brakes. I also stupidly gave the sensor a bit of a tap to try and get it out but only lightly. Now the MOT retest is this friday and the tester said he would fail it if the ABS light is on.
Apart from ripping the dash out does any one know a way to fool the ABS to get rid of this message as my credit card can't take any more and i need the car to pass the MOT.
I can't get the sensor out to test it as its rusted solid into the hub. IS there a way to test what the problem is or if there is infact a break in the circuit??
Thanks
When i was smacking the hell out of the ball joint my hammer slipped and has cracked a the plastic on the sensor but the wires inside all seem fine with no brakes. I also stupidly gave the sensor a bit of a tap to try and get it out but only lightly. Now the MOT retest is this friday and the tester said he would fail it if the ABS light is on.
Apart from ripping the dash out does any one know a way to fool the ABS to get rid of this message as my credit card can't take any more and i need the car to pass the MOT.
I can't get the sensor out to test it as its rusted solid into the hub. IS there a way to test what the problem is or if there is infact a break in the circuit??
Thanks