F

Frank T

New Member

• Mar 13, 2018

• #1

Good Morning one and all,

I am in the planning stage of a rebuild so I am getting costs together etc. I am looking at Bulkheads??

I have a 1986 90 and I may need to change the bulkhead during the rebuild....

So my question is what is the difference between early 90 bulkheads and the later ones.
I may be able to refurbish mine it seems in a reasonable condition so this is just research in case a good later 90 bulkhead comes up.

Is there a document or book that explains the differences, any adaptions to make different models fit etc.

Thanking you all in advance....

 

Sting Ray

Well-Known Member

• Mar 13, 2018

• #2

300tdi bulkeads are different to 200tdi and 19J bulkheads, due to the different gearboxes (R380 vs LT77) and the tunnels that sit over them. I believe that td5 bulkheads can be fitted to 300tdi with a couple of mods. TDCi bulkheads have been fitted to 300tdi etc, but requires more work.

If I were you, repair your one

 

H

Hicap phill

Well-Known Member

• Mar 13, 2018

• #3

Depends on what was the original engine.
Mine 110 v8 1985.
Wide tunnel so I can swap to a 300tdi. Using floor pans tunnel/ seat box.

You can buy every panel to rebuild your bulkhead but will take time & make sure it does not twist.

There are small changes to 200/300 bulkheads like top vents but rest of it you should be able to swap. You will need to use your old loom

 

Gmacz

Well-Known Member

• Mar 13, 2018

• #4

I have an 85 90 on a C reg.
If not completely rotten then new panels and weld away.

 

Attachments

• 
  20170214_114943.jpg

  228.1 KB · Views: 168

Last edited: Mar 13, 2018

H

Hicap phill

Well-Known Member

• Mar 13, 2018

• #5

My mats hide most of that rust

 

R

Rodeo Joe

Well-Known Member

• Mar 13, 2018

• #6

Gmacz said:

I have an 85 90 on a C reg.
If not completely rotten then new panels and weld away.

Click to expand...

Wish mine looked that good