dieselmonkey
Member
I'm keeping my eye out for a reasonably priced bulkhead for my '86 2.5 N/A 90.
Ideally I'd like to get a galv one, but not sure if funds will permit. Basically the O/S Door pillar is as rotten as a pear and the N/S vent area has rust. It also looks like a repair has been done on the O/S vent at some point.
I haven't stripped it down yet, however as soon as I start to I think I will find more hence keeping an eye out for a reasonably priced replacement rather than welding repair panels on.
Would the TDCI bulkhead fit? I understand the 200 and 300tdi units need some fettling around the gearbox tunnel to fit. Is this all? I've had a search around but can't seem to find much.
A definitive list of what would need doing to each bulkhead would be good.
Ideally I'd like to get a galv one, but not sure if funds will permit. Basically the O/S Door pillar is as rotten as a pear and the N/S vent area has rust. It also looks like a repair has been done on the O/S vent at some point.
I haven't stripped it down yet, however as soon as I start to I think I will find more hence keeping an eye out for a reasonably priced replacement rather than welding repair panels on.
Would the TDCI bulkhead fit? I understand the 200 and 300tdi units need some fettling around the gearbox tunnel to fit. Is this all? I've had a search around but can't seem to find much.
A definitive list of what would need doing to each bulkhead would be good.