So long as the pipe is the correct bs standard , usually copper ,and is produced using the correct tools etc then that will be fine I'd be more worried about bleed nipples shearing off resulting in even more parts etc drilling tapping or replacing , it's never as easy as that on a Landy !!! You may have a bigger job than you think !!!!! I'd go round and crack em off if you can !!!!!!!
 
who made a brake pipe on your car which had a replacement pipe on it made 6 years ago.?

Not having a go, considering my disco, when I bought it had full service history from day 1. Just passing on what I have learnt in the past few years of owning and maintaining 2 Disco's. Admittedly I still consider myself a noob at this, but if I need to facilitate the need of a garage I tend to hassle them endlessly for info that will help me not use them again.

I was merely passing on information given to me by a MOT certified garage, if the info is incorrect then feel free to slap me silly with summat!
 
Woke up this morning and found out that in my drunken stupor I had found the part number, ANR 1767, and attempted to order it online!
Obviously the payment page was way too much for me in my drunken state as it was still open.
Could someone just confirm for me that the part number is the correct one for the left side caliper to flexible hose.

Regards
 
Thanks Stuart.
I have had to leave the car at my sons house and I am off on holiday tomorrow.
If it's ok I will give you a shout when I get back.
Regards

Andy
 
Woke up this morning and found out that in my drunken stupor I had found the part number, ANR 1767, and attempted to order it online!
Obviously the payment page was way too much for me in my drunken state as it was still open.
Could someone just confirm for me that the part number is the correct one for the left side caliper to flexible hose.

Regards

that is the part number but if stuart can make you one then you're sorted:)
 

Similar threads