biggeeeee
Retired - Living the dream
Please don't say that.,might be pension day,so he can go out for his monthly treat meal,big mac and a coke.
And sit with his stretchy pants on all day
And sit with his stretchy pants on all day
gemsdad
NOT BOTHERED.
And maybe his adult anti dribbling pantsAnd sit with his stretchy pants on all day
gemsdad
NOT BOTHERED.
sierrafery
Well-Known Member
It can happen if one of the two pistons of a caliper is sticking ...did you check the calipers too?, if not there are quite cheap rebuild kits available, e.g http://www.island-4x4.co.uk/brake-caliper-seal-stc1919g-p-196.html
This might help........
Headtester
Active Member
Could be the Electronic Brake Distribution valve?
From Rave:
From Rave:
Operation of EBD is detectable from a stiffening of brake pedal movement as the inlet solenoid valves close and a
slight pulsing of the brake pedal as the inlet solenoid valves open. EBD operation ceases immediately the brake pedal
is released.
slight pulsing of the brake pedal as the inlet solenoid valves open. EBD operation ceases immediately the brake pedal
is released.
Ahaggar
Active Member
Had a very bad pulsing and just on hard braking a judder in the steering wheel when the wheel bearings were shot. But the problem was just there when you stepped on the breakers. When the pads managed to steer the wheel bearings in the right position the breaking was great.
jimalmighty
Member
I had a similar thing, thought it was the ABS module but I changed the wiring loom in the rear near side hub and it cured it. Cost £80 for the loom
jimalmighty
Member
Mine did throw up the three amigos tho
