mikegsxr

Active Member

• Mar 13, 2021

• #1

Morning all,
Finally getting around to a major overhaul of the 110s brakes. New discs, caliper strip, paint, new SS pistons etc. Mine has ABS and I'm not sure how the hub is split from the disc as the pulsar ring covers up the bolts, see pic below. Trying to make sure I have all the bits I need before it's off the road.
Has anyone been here before me and done the job?
Cheers,
Mike.

 

Cavey_P38

Well-Known Member

Full Member

• Mar 13, 2021

• #2

Does the ABS ring not unbolt from the other side.

Rest of job fairly simple to take apart and refit.

Re Calliper overhaul, that goes ok providing the caliper isn't too rusty and pitted. Stainless Steel Piston are a good idea, did them on my 90 couple of years ago.

Hope you purchased good quality delphi or Ap lockheed seal kits as cheap ones don't last or even fit

Good luck

 

Europa486

Well-Known Member

• Mar 13, 2021

• #3

You should have small studs sticking out the front,

 

mikegsxr

Active Member

• Mar 13, 2021

• #4

Cheers for that, reckon I'll find them once i've dug all mud out and I know now where to look.

 

Al2O3

Well-Known Member

Full Member

• Mar 13, 2021

• #5

mikegsxr said:

Morning all,
Finally getting around to a major overhaul of the 110s brakes. New discs, caliper strip, paint, new SS pistons etc. Mine has ABS and I'm not sure how the hub is split from the disc as the pulsar ring covers up the bolts, see pic below. Trying to make sure I have all the bits I need before it's off the road.
Has anyone been here before me and done the job?
Cheers,
Mike. View attachment 233087

Click to expand...

Your stub axle looks a bit ropey.

 

mikegsxr

Active Member

• Mar 13, 2021

• #6

That pic was a couple of years ago.Stub axle sorted, discs worn out...

 

Al2O3

Well-Known Member

Full Member

• Mar 13, 2021

• #7

mikegsxr said:

That pic was a couple of years ago.Stub axle sorted, discs worn out...

Click to expand...

Tremendous. Wasn't meaning to be a pain, was just thinking it would be worth swapping them while you're in there.

 

mikegsxr

Active Member

• Mar 13, 2021

• #8

Took a bit of effort to remove...cleaned up nicely in the lathe