v8discoian
New Member
Hi All,
OK so another question on this axle rebuild I am going through at the moment.
I have split the calliper (yes I know they are a bugger to re-seal but I have plenty of time, although now I have said that I'm sure the axle on the truck will fail tomorrow lol)
Anyway.... Now ordering the seals etc however I have noticed that one of the galleries is completely blocked. These are single pipe callipers for solid discs. What is the best way to unblock it, what should I leave it socking in lol
I have pushed both pistons back on that side of the calliper and they both go back and push fluid out of the single gallery hole that is not blocked.
Hope that makes sense. Picture below with blockage circled in the normal colour for issues RED
OK so another question on this axle rebuild I am going through at the moment.
I have split the calliper (yes I know they are a bugger to re-seal but I have plenty of time, although now I have said that I'm sure the axle on the truck will fail tomorrow lol)
Anyway.... Now ordering the seals etc however I have noticed that one of the galleries is completely blocked. These are single pipe callipers for solid discs. What is the best way to unblock it, what should I leave it socking in lol
I have pushed both pistons back on that side of the calliper and they both go back and push fluid out of the single gallery hole that is not blocked.
Hope that makes sense. Picture below with blockage circled in the normal colour for issues RED