P

pornstarmax

Active Member
Tried everything to get Bottom arm on steering rely box off, anyone got any smart or novel idea's....

Ta

MX!!!!!
 
I hammered a chisel into the split to spread it a bit and then used a wedge (ball joint splitter) hammered into the gap between the relay and the arm. Brutal, but effective. Never got the actual relay out, though.
 
Yeah I did the same - I went as far as hammering the ball joint splitter in as far as it would go then getting a jack under it!!!!!!!!!


Didn't move.....

Tried heat

Tried Plus gas

Next is grinder and new relay box.....
 
Last edited:
just done one on me slitty ( hack ptooh spit ) heated it up with acetylene didnt work tried a bearing puller kept slipping off so in the end cut a slit in the fekker with a grinder and hammered a bolster chisel into the cut then leathered it off with a 4lb lump hammer was a complete twot to get off
 
wait till you try and get relay out unless truck is in as new condition,put wider wedge in,hit with hammer on one side and another to take shock on other on outside of arm around shaft it will stretch it like removing ball joint it will come off
 
Try getting a long bar between the arm and chassis to get some leverage and get someone to press down hard on the bar whilst you hit the arm.
 
You could try removing the relay retaining plate followed by the relay bottom plate and then knock the whole shaft out - you can then get at the *'stard on the bench. I am assuming the top arm is off?
 
I have just done it...... Don't wreck the box, just kill the steering arm! I got a hacksaw and carefully cut very close to the splines but not damaging the box shaft. I then got some heat on the cut area, after which it was glowing. I then threw some very cold water on it and hit it with a lump hammer. Then it cracked and decoupled.

Hope this helps.
 
Got the fecker!!!!

Left it over night in a bag FULL of plus Gas. Then hammered in a wedge, then heated it, then got a jack on the ball joint splitter!!!!!!!!

Unbelievible...............
 
philvy said:
If you know where to get a new chassis for 50 quid let me know. Me is interested :D
Click to expand...


You can have this for £50,give me £25 now and £25 when I send you the other half :D

Image28-1.jpg
 
You must log in or register to reply here.

Similar threads

S
rattle from steering bearing
Replies
5
Views
490
sprie
S
CakeBandit
death wobble question
Replies
5
Views
1K
steve2286w
steve2286w
C
Td5 steering issue
Replies
5
Views
704
Corris110SW
C
J
Steering Leak?
Replies
8
Views
831
JRo
J
S
Location of Relay Box
Replies
3
Views
317
Wildefalcon
W