Datatek
Well-Known Member
No clips on mine, it seemed that the plastic had deformed so that the clips no longer latched. I fitted an LED strip across the width of the hatch and glued the old plastic lens in place with a small spot of hot melt glue at one end. I can see every darn dog hair with the LED strip LOL.
P38Seb
Well-Known Member
EBay led light - this is what I have now. Plug and play replacement. FYI it’s a very snug fit!
Flossie
Well-Known Member
Powerful UK, got my replacement auto gear knob off them.
I'll get one ordered up, Ta.
Me too. It doesn't fall out & lights up the boot area much better than the original.
Mine was replaced with a powerful_uk unit as well. Lights the whole area nevermind the boot space
cornishboater
Well-Known Member
Bought 2 from PowerfulUK and now have one each side, there is actually an indent for one 
cornishboater
Well-Known Member
The LED bulb in my reverse lights make a big differenceSame price on ebay as their website , ordered off ebay to save filling in all the website details.
Pity the 38 doesn't have a remote upper tailgate release, could use the led lamp as a reversing light then when backing down my gloomy drive at night.
P38Seb
Well-Known Member
Is there wiring for it as well? Might fit another then! Not that it’s needed!Bought 2 from PowerfulUK and now have one each side, there is actually an indent for one
cornishboater
Well-Known Member
I just put in Y connectors and tapped off of the one lamp, even colour coded the additional wires
cornishboater
Well-Known Member
It does actually make visibility a lot better, as Keith says though, sometimes a tad too much, LED light is unforgiving!!!
I got an LED strip one to go right across the tailgate and slipped the wires past it. The wires tightened it up so now I have both.
Flossie
Well-Known Member
It's that snug I can't get it in! I think something will break if I try any harder....I might have to relieve the aperture slightly, hope I don't end up with a fall outty led lamp
cornishboater
Well-Known Member
You do have to remove a bit of material to fit it, easy does it HomerIt's that snug I can't get it in! I think something will break if I try any harder....I might have to relieve the aperture slightly, hope I don't end up with a fall outty led lamp
Flossie
Well-Known Member
Hold ma beer ,Where's me 9" grinder.
Got mine in there, but it was a real struggle.
