Jamesyhunt21061988
New Member
Hi I've bought a pressure boost gauge psi and wondered if anyone had fitted one of these and if they found it to work
Winu
Active Member
I got one and it work 
boost1 - YouTube
17 PSI Peak (when wastegate opens) , 15 PSI full boost.
Just plug it in with T piece before your MAP sensor, and it's done
boost1 - YouTube
17 PSI Peak (when wastegate opens) , 15 PSI full boost.
Just plug it in with T piece before your MAP sensor, and it's done
Last edited:
Jamesyhunt21061988
New Member
Thankyou, where did you lead the pipe through the car an were did you fit there boost gauge
kev1nlm
Active Member
I plumbed mine in as per Winu's description I mounted mine to the right of the dash pod and through the grommet on the drivers side of the bulkhead, I wired it into a spare fuse holder on the fuse board which was an ignition feed so I only needed a male spade connector job done!!
Winu
Active Member
The same way as above, but use a wire channel on the left top of bulckhead (place where wires from ECM goes - there is plenty of space) Mine is LHD, so it sits on the left side of gauge cluster (as you can see on movie)
Last edited:
Jamesyhunt21061988
New Member
Thankyou for information going to try and do it over the weekend
essexpestcontrol
New Member
forgive me for being thick, but what does that clock actually tell you? how does it make the freebie any better? or is it just another clock to look at?
