julianf

julianf

Well-Known Member
Opening the bonnet on the 110 is a 2 person job - one person to pull the release, and the other person to bump (push down on) the bonnet, before it will pop up into the usual position (where you can then get your fingers under to move the catch to the side)

Now this will, i suspect, be due to the general twisted nature of every panel on this vehical, but it gets irritating as, every time i want to do anything, i need to summon my (un)happy helper.

Anyone encountered this before, and can advise me which bit to hammer (or otherwise?)
 
Bonnet striker plate or pin, worn or damaged.
Always a bit of a fiddly job, but easily obtained replacement parts. Sometimes turning the pin 90deg works.
Worth checking bonnet release cable not stretched or seized.
 
Have you tried adjusting the cable or even renewing the cable could be a little rusty and not opening enough.
 
Not tried anything yet. Only had truck a short time and had just assumed it was a mis shapen bonnet.

Will try the suggestions above - thank you.
 
I have a 300tdi 90 with the spare wheel on the bonnet. The bonnet doesn't even try to pop up when I pull the release cable. I keep a wooden clothes peg attached to the pull handle. when I need to open the bonnet I just pull the release cable out and put the peg on the cable behind the handle. I can then go around to the front of Landy and pull the bonnet up enough to reach the catch and lift the bonnet.
 
Doey68 said:
I have a 300tdi 90 with the spare wheel on the bonnet. The bonnet doesn't even try to pop up when I pull the release cable. I keep a wooden clothes peg attached to the pull handle. when I need to open the bonnet I just pull the release cable out and put the peg on the cable behind the handle. I can then go around to the front of Landy and pull the bonnet up enough to reach the catch and lift the bonnet.
Click to expand...
Slightly OT but I believe that one of the reasons for moving the spare wheel from the bonnet to the side mount on the Wolf was that the bonnet would flex under the weight of the wheel and could damage the injector pipes on the engine (also a 300). Might be worth keeping an eye open for that.
 
Kwakerman said:
Slightly OT but I believe that one of the reasons for moving the spare wheel from the bonnet to the side mount on the Wolf was that the bonnet would flex under the weight of the wheel and could damage the injector pipes on the engine (also a 300). Might be worth keeping an eye open for that.
Click to expand...
I hadn't heard that Kwakerman. Thanks for the heads up. I'll check it out.
 
Have had a 255/85/16 bonnet mounted for many years, including over 25,000 miles on non sealed surface road without issue.
Admittedly have chequer plate on the bonnet.


Brendan
 
The slot in the bonnet pin can be used to adjust the length against the spring ... maybe a tweak is in order ...
and make sure the slider is moving freely when the cable is used ...
 
Mine used to do that and I smeared some grease on the pin and the hole. After I did this it opens straight away
 
You must log in or register to reply here.

Similar threads

K
What money should I be asking?
2
Replies
27
Views
4K
Karls
K
B
Blower / Heater Motor squeak-Hum at slow speeds.
Replies
7
Views
928
JohnKeane
J
Henry_b
EAS Pump Noise + A Handy hint eh!
Replies
3
Views
689
Rubberknees
Rubberknees
Andy Warren
Tailgate won't open
Replies
3
Views
670
Alibro
Alibro
R
Defender 90 1998 R Reg 300tdi hardtop for sale
Replies
7
Views
3K
Rob308win
R