wickford90
Well-Known Member
Couple of question, is it ok to get panels dipped to strip off paint, worried about ally, and residue left in crevasses. Need to repair panels that have had holes drilled in, what best long term solutions.
matthew2riches
New Member
Geoff - if you call me tonight or tomorrow I can talk you through a little gadget I recommend
I'll be about here till midnight if you want to bell me.
wickford90
Well-Known Member
Geoff - if you call me tonight or tomorrow I can talk you through a little gadget I recommend
Will give you a ring tomorrow pm.
Javelinadave
Active Member
I had my entire truck soda blasted last week. Afterwards I just washed it down with soap and water and it is ready for priming and paint.
Before:
After:
Before:
After:
Last edited:
wickford90
Well-Known Member
Not familiar with soda blasting, is this a dip into liquid, or blasted as in shot blasting.
matthew2riches
New Member
Are you doing something to your Series?
Javelinadave
Active Member
Blasted with baking soda. It doesn't heat up or deform the aluminum like sand blasting does.
There is at least one soda blaster in the UK:
http://www.sodablasteast.co.uk/
There is at least one soda blaster in the UK:
http://www.sodablasteast.co.uk/
Last edited:
