Yup, my turn for the blend motors problem!
From the wealth of information available I think I'm clear on what needs to be replaced but I wanted to list my symptoms here and get a double check on what I'm thinking, so
Symptom: I can't get any hot or cold air to blow into the cabin. Just ambient temperature.
Supporting info:
- Workbook symbol displayed.
- Tried full HI and LO settings, makes no difference.
- Can direct air to the dash, feet, face OK, its just always the same ambient temp.
- Checked all fuses and relays.
- AC pipes don't get cold at all.
- A few months ago I had water in the passenger (UK car, aka nearside) foot well, not happened again since, have checked the drains are clear and replaces the pollen filters since then (maybe I didn't put one of the pollen covers in place properly the service before?).
- 2 Years ago I serviced the AC system (replaced pressure switch, dryer) and had it re-gassed, was fine after that.
So I'm thinking its the blend motors (STC3259) that need replacing.
Also thinking do the O-rings while I'm having fun (STC3262).
Does my thinking make sense?
Am I going to order the right bits?
Is there anything else I should consider getting/fixing while I'm doing the job?
Many thanks for any input.
From the wealth of information available I think I'm clear on what needs to be replaced but I wanted to list my symptoms here and get a double check on what I'm thinking, so
Symptom: I can't get any hot or cold air to blow into the cabin. Just ambient temperature.
Supporting info:
- Workbook symbol displayed.
- Tried full HI and LO settings, makes no difference.
- Can direct air to the dash, feet, face OK, its just always the same ambient temp.
- Checked all fuses and relays.
- AC pipes don't get cold at all.
- A few months ago I had water in the passenger (UK car, aka nearside) foot well, not happened again since, have checked the drains are clear and replaces the pollen filters since then (maybe I didn't put one of the pollen covers in place properly the service before?).
- 2 Years ago I serviced the AC system (replaced pressure switch, dryer) and had it re-gassed, was fine after that.
So I'm thinking its the blend motors (STC3259) that need replacing.
Also thinking do the O-rings while I'm having fun (STC3262).
Does my thinking make sense?
Am I going to order the right bits?
Is there anything else I should consider getting/fixing while I'm doing the job?
Many thanks for any input.