Hello fellow leafer's.
I decided to change the weeping flexi hose on the clutch. It was a faff, but got there in the end.
The problem is, it just wont bleed up, so I though the master cylinder was weak, so changed that too, along with a new pipe to the flexi.
still no differance, i know all connections are tight, even put a new bleed screw in the slave clinder, with still no result.
The question is do I go ahead and change the slave cylinder now, as its the only thing that has not been replaced, or is there something obvious that I have missed. Every thing was fine before I changed the flexi( it just weeped, and I topped the fluid now and then.)
Just "clutching" at straws now and banging head and getting no were...
Any pointers !!!! apart from a box of Swan vesters....
I decided to change the weeping flexi hose on the clutch. It was a faff, but got there in the end.
The problem is, it just wont bleed up, so I though the master cylinder was weak, so changed that too, along with a new pipe to the flexi.
still no differance, i know all connections are tight, even put a new bleed screw in the slave clinder, with still no result.
The question is do I go ahead and change the slave cylinder now, as its the only thing that has not been replaced, or is there something obvious that I have missed. Every thing was fine before I changed the flexi( it just weeped, and I topped the fluid now and then.)
Just "clutching" at straws now and banging head and getting no were...
Any pointers !!!! apart from a box of Swan vesters....