S

Side-show-bob

Active Member

• May 2, 2008

• #1

Hi all

Is there a list anywhere or dose anyone know where i can find out the bearing sizes for the rear axle/hub set-up. I work in engineering so i have access to suppliers and old redundant stock in our store, i was wondering if any of the bearings/oil seals i have laying around will fit.

I was going to strip it and measure them all up but i really need to get it done ASAP, so any information i can collect before hand will be a great help.

Cheers
Rob

 

T

TheSmiths88

New Member

• May 2, 2008

• #2

Bob ... if you're really in a hurry, new oil seals start at less than a quid and bearings around a fiver at Paddocks. you might be better off doing half an hour's overtime and simply buying new ... ?

 

S

slob

Well-Known Member

• May 2, 2008

• #3

it would have to be reet old stock as series bit are imperial and most newer fitments are metric

 

S

Side-show-bob

Active Member

• May 2, 2008

• #4

We have loads of stock we run 60year bottling plant and american which helps when you need imperial fixings..

 

S

slob

Well-Known Member

• May 2, 2008

• #5

Side-show-bob said:

We have loads of stock we run 60year bottling plant and american which helps when you need imperial fixings..

Click to expand...

ah take it english int yer first langauge?

 

S

Side-show-bob

Active Member

• May 2, 2008

• #6

No its actually Yorkshire

 

S

slob

Well-Known Member

• May 2, 2008

• #7

Side-show-bob said:

No its actually Yorkshire

Click to expand...

do yer mean english is yorkshire or that your first langauge is yorkshire?
not that it matter cos neither of em make sense

 

steve2286w

Well-Known Member

• May 2, 2008

• #8

try this link, but best use paddocks/craddocks beforehand to check numbers as there are different sizes, you might find like mine different on both sides obviously changed sometime in past


Ottawa Valley Land Rovers - Miscellaneous - Alternate Parts List