Side-show-bob

Active Member
Hi all

Is there a list anywhere or dose anyone know where i can find out the bearing sizes for the rear axle/hub set-up. I work in engineering so i have access to suppliers and old redundant stock in our store, i was wondering if any of the bearings/oil seals i have laying around will fit.

I was going to strip it and measure them all up but i really need to get it done ASAP, so any information i can collect before hand will be a great help.

Cheers
Rob
 
Bob ... if you're really in a hurry, new oil seals start at less than a quid and bearings around a fiver at Paddocks. you might be better off doing half an hour's overtime and simply buying new ... ?
 
it would have to be reet old stock as series bit are imperial and most newer fitments are metric
 

Similar threads